Filter By:
Other
$64.50
A rear brake cable hanger which provides a cable stop for rear centerpull and cantilever brakes
- Pivots to align the cable with the brake, regardless of frame geometry
- Includes barrel adjuster
- Attaches to the seatpost itself, and the clamping surface has no lip
- Fits 27.2mm seatpost
$52.50
The ultimate fancy straddle wire holder
- Integrated cable clamp & 8mm hex so you can put a wrench on it
- Moon Units come as a set of 2
$88.50
Mounted in place of a front derailleur, the Chain Keeper works with single and 1x multi speed drivetrains using a narrow chain. The chain block surrounds the chain as it meets the chainring and prevents it from skipping off.
- Accommodates a range of chain line measurements and chainring sizes
- Not designed for downhill/freeride/big hit use
$131.00
Paul Components Melvin Chain Tensioner. Converts frames for single speed use. Long enough for a Dingle-setup, (2 rings, one cog) 20T max.
- The Melvin uses two pulleys, just like a rear derailleur, which gives it 20 teeth of chain wrap
- Will work with multiple front chain rings while maintaining proper chain tension
- The pulleys are made of extruded and machined aluminum and have sealed bearings for durability
- Pulleys are 2.25mm thick at the tooth which fits inside most narrow 6 through 9 speed chains, and the pulley cage is wide enough to allow 1/8? single speed chains as well
- Long enough for a Dingle-setup, (2 rings, one cog) 20T max
- Do not use with a coaster brake or fixed gear
- Includes Paul's own Sealed Bearing Pulleys
$7.00
Replacement parts for Paul rim brakes.
$24.00
A pair of anodized Spring nuts for use with any Paul Component rim brakes.
- Replacement spring adjusters to fit any Paul rim brake
- Machined in the USA of 6061 Aluminum
- Sold per brake
$8.00
Replacement parts for Paul rim brakes.
$137.00
Paul's dropper trigger with stacked dual sealed cartridge bearings, two different cable clamp options, a barrel adjuster, and a hinged clamp.
- Dual stacked sealed cartridge bearings in the pivot for zero slop and long (serviceable) life
- Pinch bolt and cable head recess allowing you to run the cable in either direction
- Hinged clamp so you can install it without removing the grip
- Barrel adjuster for fine tuning the cable tension
$59.50
This little goodie allows you to mount any SRAM underbar trigger shifter to a 31.8 dropbar.
Why do you need this? Doesn’t SRAM make their own road shifter?
Well, yes they do. But none of them are compatible with the awesome 10-42t spread found on their mountain 1x drivetrains.
- 6061 Aluminum
- Fits 31.8mm handlebars
- Compatible with SRAM MTB RH shifters (not included).
$127.00
Thumbies are the original upright handlebar mount and easily transform bar end (aka barcon) shifters into thumb shifters.
- 6061 Aluminum
- Fits 22.2mm handlebars
- Hinged clamp for easy installation
- Compatible with Shimano bar end shifters (not included)
- Updated! now have raised platforms to clear hydraulic disc brake levers
- 60g
Page 1 of 1